Angwee Widdle Gweedy Ghost Candy & Popcorn Bowl

Don't wet dis wittle ghost....eherm....don't let this little ghost scare you away, it's cheeks are full of candy and not planning to share with you! I think it took all the chocolate from some Trick or Treaters!

Is it a tooth? Maybe a ghost of a tooth...not ready to leave this Earthly realm..ooOOOOhhhHHHhhhh...

There is something spooky about this printable that if you read to the end, is sure to creep you out....

Feed it if you dare but beware, it doesn't like when you take from it!

Steal some candy from the top or the mouth. Looks great on a desk or on your front porch. But watch out for that mouth...this little ghostie may not have teeth but I swear it bit me the other day.

Hopefully this sweet little apparition is scary enough to make everyone take only 1 piece this year!

It features flat feet for ultra stability when it's full of 200 or so pieces of candy.

After Halloween, make sure to load it up with your favorite corn chips or popcorn and continue the spooky spirit!

True story: I accidentally printed this larger version and waited for it to print...It took way longer than 2 days that the slicer estimated for 60 mm/s, so I got worried but the print was turning out fantastic and I let it do its thing...It kept printing furiously throughout the night of the 2nd day and when I awoke, I carefully made my way over to the 3d printer where a massive completed candy bowl that resembled a tooth awaited me. I glanced down at the time it took...The print time ended up being 66 hours and 6 seconds. See attached photo. SPOOKY, no?

Happy Halloween!

Make sure to check out my other designs, like my Ghost Candy Tray to hold more candy!
https://cults3d.crackfree.org/en/3d-model/home/cute-ghost-candy-tray

And my Spooky Ghost Kitty Memorial Statue
https://cults3d.crackfree.org/en/3d-model/art/kitty-ghost-on-cloud-base

And my Chameleon VR holster to rest your tired hands and keep your phone within arms reach at all times!
https://cults3d.crackfree.org/en/3d-model/gadget/the-chameleon-vr-holster

This prints very easily on my stock Elegoo Neptune 3

*Strong strength glue stick like "UHU stic" applied to build plate highly recommended for the feet!
Find it here https://amzn.to/3ISXlUS

Nozzle temp: 215-220°C

Nozzle size: 0.4mm

Layer height: 0.3

Wall thickness: 2mm

Bottom thickness: 1.2mm

Infill density: 10-15%

Infill: Gyroid

Top/Bottom thickness: 2mm

Print speed: 40-60mm/s (40 highly recommended if you scale it down from original size)

Initial layer line width: 108% (slightly more than 100% gives me good adhesion and lines for a better looking bottom)

Initial layer speed: 10mm/s

s: Tree, Lines

Overhang: 70°-80°

Pattern: Lines, Grid

Adhesion: Draft Shield 1-2mm away from print and at least 10mm in height, Brim optional 1-3mm