How to Take Off 3D Print

Sometimes, removing a 3D print from the build plate can be challenging. Find out how to safely take off a 3D image.

A 3D print can get stuck onto the build plate for various reasons. Sometimes, it may result from poor first layer adhesion. However, applying too much bonding onto the build plate can also cause issues. Both instances can make removing the 3D print quite risky and challenging. Nevertheless, it is essential to know how to deal with such problems without damaging the image. The following article will discuss the easiest ways to take off a 3D print.

Apply a Little More Force

Most of the time, you need to apply a little more force to get the print off the build plate. However, let the print bed cool down for a considerable amount of time before touching anything. Hold the plate in place and push or pull the print from the surface with the other hand. However, you must caution not to apply too much force that could slam your hand or tear off the image.
The above method should only be ideal if your print is a strong material. 3D images with many details and small features are more likely to get torn during the process. So, exercise a lot of caution when applying force.

Use a Flat Blade or Scrapping Tool

A flat blade such as a filling knife, spatula, or a plastic razor blade can also effectively remove a 3D print from the build plate safely. However, safety should always take precedence when pursuing the option since you could quickly get injuries. One way to prevent injuries is pushing the blade away from yourself. Also, be careful not to scratch the print and the build surface with the edges.
Removing a 3D print with a sharp blade also requires a little bit of pressure underneath the image. Hold the 3D model carefully, then wiggle the product gradually until the adhesive weakens, releasing the print.
While your 3D printer may have a scrapping tool, it may not be the best for the job. The Raptor 3D Print Removal Tool Kit is the best tool, which you can now easily buy online, even with cryptocurrency. Bitcoin Prime is one of the trusted platforms that can help you make seamless online purchases in crypto.

Heat the Print Bed

Sometimes, the adhesive has hardened, making separating the print from the bed hard. Besides, print materials usually reach the heat. Thus, re-heating the print bed will soften the material, decreasing the adhesion to the print bed. However, you should keep the temperatures at about 70 Degrees since too much heat could also destroy the model.

Freeze the Print Bed and Model

Temperature changes can quickly push out the stuck prints in your print bed. Thus, one of the ways to try it out is by spraying compressed air onto the stuck images to force them out. Placing the print bed and the model in the freezer can also impact the contraction of the plastic, prompting the print bed to loosen its grip on the model.

Use Dental Floss

A small force is usually sufficient to dislodge a stuck 3D print from the print bed. However, that is not often the case. The technique mainly involves holding the dental floss between your hands and placing it at the back of the print, close to the bottom, then pulling it towards you slowly. Dental floss is one of the most straightforward and successful removing stuck 3D images.
Overall, various alternatives exist for taking off 3D prints from the print bed. However, the methods discussed above are the most effective ones, with fewer risks.